which side is up?

which side is up?

Postby kevdiggler77 » Wed Jun 22, 2011 4:44 pm

I know the "shiny" side goes up but on the black and silver camo I cant tell.There are some numbers going up the side,are the numbers on the"shiny side or the dull side?
kevdiggler77
 
Posts: 9
Joined: Mon Jun 13, 2011 7:06 pm

Re: which side is up?

Postby vincent » Mon Jul 18, 2011 7:40 am

I have a small squirt bottle of acetone i put some on my finger and apply to the corner of the film i have cut out to make sure i have it the right side up before i put on the water. if the ink comes off i have the right side up.
vincent
 
Posts: 8
Joined: Mon Jul 18, 2011 7:11 am

Re: which side is up?

Postby admin » Sat May 31, 2014 6:01 am

Wet your fingers & pinch the corner of the film....the sticky (water soluble side) always faces down on the water. This applies to any film on the market.
EpTex Coatings Technical Support
admin
Site Admin
 
Posts: 5
Joined: Fri May 13, 2011 3:36 pm
Location: EpTex Coatings


Return to FAQ

Who is online

Users browsing this forum: No registered users and 1 guest

 
Copyright 2008-2014 ElPasoPowderCoating.com. All Rights Reserved. Site created by: Acera Technologies. EPTEX Coatings - El Paso Powder Coating & Hydrographics LLC - 5559 El Paso Drive, El Paso, TX 79905 - 915-313-9333


Google+
El Paso Powder Coating & Hydrographics LLC: 31.769902; -106.42292
This page is geo-coded
Acera Technologies - Helping You Reach the Four Corners of the Globe! Mobile: Click to Call 915-313-9333 Google Map - EPTEX Coatings - El Paso Powder Coating & Hydrographics
cron