Supported by a welded steel frame, this box brake can bend metal along its 10-foot width without twisting. You can bend 4 x 8 sheets at 45°, perfect for adding a stiffening rib to support long duct pieces.

• Maximum capacity of 14 gauge mild steel and 18 gauge stainless steel.
• 10-foot (120”) length enables your shop to take on a wide range of projects.
• Bends up to 135°.
• 26 fingers of varying sizes (6 fingers of 3″, 4 of 4″, 10 of 5″, 6 of 6″) allow you to bend boxes and pans up to 6” deep.
• You can set up the individual hardened fingers for straight bending or box and pan configurations.
• Apron shafts ride in precise oilable bearings, maintaining tight bend tolerances and minimizing operator fatigue.
• 2 massive counterweights make it easy to bend at maximum capacity and reduce physical strain.
• Heavy-duty truss rods support the apron to reduce flex on maximum capacity bends.
• Electro-welded all-steel framework keeps this metal brake accurate over decades of daily use at full capacity.
• Massively-built sheet metal finger brake weighs in at almost 3500 lbs.

Recommended for: General fab shops or HVAC shops.

SPECIFICATIONS

* specifications subject to change without notice.

California Proposition 65